kenwood th 75E

Alles over zend(ontvang)ers en toebehoren.
Plaats reactie
Bericht
Auteur
on3dag
Berichten: 158
Lid geworden op: 30 nov 2014, 16:49
Roepletters: on3dag

kenwood th 75E

#1 Bericht door on3dag »

Zou er iemand mij kunnen mededelen welk een diode ik moet wegnemen van de kenwood th75E om deze over de ganse band te laten scannen, dus ik feite de transceiver open zetten.
Alvast mijn dank,
Dirk

Gebruikersavatar
PE2AAB
Moderator
Berichten: 7089
Lid geworden op: 12 apr 2005, 19:06
Roepletters: PE2AAB
Locatie: Aalst - Waalre
Contacteer:

Re: kenwood th 75E

#2 Bericht door PE2AAB »

Bij mijn weten is Kenwood altijd een 'green wire' cut.

Inderdaad. Zie mods.dk
This modification will allow the TH-75A to transmit from 142 to 152 MHz and 420 to 450 MHz. Specifications are guaranteed for the Amateur Bands only. Through the transceiver will display 136 to 174 MHz and 335 to 512 MHz, the PLL circuit may not lock through the entire range.

Modification procedure
Disconnect the battery and antenna.
Remove the three case screws and two battery plate screws.
Lift the front panel from the body of the transceiver, but do not disconnect the two flex cables.
Cut the green jumper wire (W1) that is located to the left side of the CPU in the front panel assembly.
Assemble the transceiver by reversing steps 1-3.
Reset the CPU by holding the M key as the power is turned on.
I have tried it and it works.
Suresh Kagoo N9GSA
'73 Rick, PE2AAB www.pe2aab.nl

Plaats reactie