Ik heb gelukkig een hoge antenne dus ik pik nog wel wat signalen uit de lucht van hoge stations (repeater in Breda enz)
Wat me opviel is dat ik vrolijk HDSDR opracht kan geven te tunen op 2400MHz maar er op geen enkele wijze aangegeven wordt dat het daar niet ontvangt, zo ontvang ik op 2299,703 een weerbericht van de Nederlandse kustwacht waarvan in vrijwel zeker weet dat het daar niet zit.
Dus ik heb helaas geen manier om te zien tot waar mijn stick werkt, onderste gebied moet ik nog even opzoeken met de signaal generator.
Heel makkelijk over de freq draaien heb ik nog niet gevonden in HDSDR (tips welkom), maar ik ben maar kort met het programma aan de gang geweest,
ik heb overigens deze instructies gevolgd om het onder win 7 aan de gang te krijgen.
-----------------------------------------------------------------------------------------------
1. Download and install
http://www.hdsdr.de/download/HDSDR_install.exe Follow the instructions and remember where you installed it to. (YOU CAN SKIP THIS STEP IF YOU SELECT TO INSTALL HDSDR VIA THE SETUP PACKAGE IN STEP 2)
2. Visit
http://wiki.spench.net/wiki/USRP_Interfaces#BETA and download the ExtIO_USRP+FCD+RTL2832+BorIP-BETA_Setup.zip setup package. While there, grab the new librtl2832++.zip (without updating it you will have a tough time and see many errors)
3. Make sure your dongle is plugged in.
4. Extract the first .ZIP you downloaded and run the installer contained within. Install to the same folder as HDSDR. During the install process, you will be asked to install the Zadig drivers. If your dongle doesn’t automatically show up, select Options then List all Devices. Select Bulk in Interface 0 (NOT 1 if that shows up) and click Install Drivers or Replace Drivers. Close the Zadig installer and complete the rest of the install.
5. When completed, extract
http://spench.net/drupal/files/librtl2832++.zip to the same folder as where you installed HDSDR (or ExtIO if you chose a different location). You may have to delete/rename the existing file before replacing it.
6. Launch HDSDR
7. Ignore errors you see on first launch. There should be two windows that open HDSDR and Device Control. Select the Device Control window and under “Device Hint” put “RTL readlen=8192 tuner=e4k” without the quotation marks. Click Create. Hopefully it should work and you can go back to the HDSDR window, click START (or hit F2) and begin tuning around.